1. Introduction of speed
2. Cutting speed
This page is used to set the moving speed of the corresponding parts when the machine is cutting.
a.[speed]
The parameter corresponds to the cutting speed of the knife/pen, and is used to limit the maximum speed that the knife/pen can achieve when cutting.
b. [acc/dec]
It corresponds to the physical acceleration. If the velocity starts from 0, the greater the acceleration is the shorter the time to reach the predetermined velocity.
c. [curve spd]
Curve speed corresponds to the speed when cutting the curve arc, and corner. Reducing the turning speed appropriately can get better cutting effect.
d. [down/up ]
It can set the speed of tools up and down when the knife/pen is working.
